Installation Manual

Wall-Mounting
975-0239-01-01 Rev J 2–7
This manual is for use by qualified personnel only
Each Conext XW+ and PDP requires a separate mounting plate. Attach the
mounting plate to the wall before you attach the Conext XW+ or PDP to the
mounting plate.
Each mounting plate requires a minimum of four ¼-inch diameter lag bolts or
other fasteners (not included).The fasteners must be strong enough to support
500 lbs (227 kg).
The type of fastener required to secure the mounting plate varies according to
the vertical surface and wall structure of your installation location. For a list of
recommended fasteners, see Table 2-1, below.
Table 2-1 Recommended fasteners
The holes of each mounting plate are spaced 16 inches (40 cm) apart, so that
the mounting plate will span two wall studs spaced 16 inches on-center.
Additional mounting holes are provided to allow for other mounting options.
Structure Required Fastener Screws Per Plate
Wood studs at 16" on-center (O.C.) 1/4" Ø × 3 1/2" long lag
screw
Four
Wood studs not at 16" O.C. (3/4" minimum
plywood panel required)
1/4" Ø × 1" long wood screw Six
Steel studs at 16" O.C. (minimum 18 gauge) 1/4" Ø self-drilling screw Four
Figure 2-4 Mounting plate dimensions
Note: If the wall does not have 16-inch (40 cm) on-center studs, you will need to
provide adequate support for the mounting plates. For example, a sheet of
plywood can be attached to the wall, and the mounting plates can then be
attached to plywood.
16”
4 ½”
2”
6”
1 ¾”
17”
6
7
8
”9
3
16
”
2 ¼”
¾”
XW-NA-Install.book Page 7 Wednesday, August 12, 2015 2:23 PM