Installation Manual

Wall-Mounting
975-0239-01-01 Rev J 2–9
This manual is for use by qualified personnel only
Wall-Mounting the Conext XW+ and PDP
To wall-mount the Conext XW+ Inverter/Charger:
1. Align the flange on the back of the Conext XW+ chassis with the bottom
edge of the mounting plate, as shown in Figure 2-7.
Figure 2-6 Two interlocking mounting plates
Figure 2-7 Wall-mounting the Conext XW+
WARNING
HEAVY EQUIPMENT
The Conext XW+ Inverter/Charger weighs approximately 120 lbs. (54 kg). A
two-person lift is required. To prevent personal injury, always use proper lifting
techniques during installation.
Failure to follow these instructions can result in death or serious injury.
Conext XW+
Mounting
Conext XW+
chassis bracket
chassis flange
plate
XW-NA-Install.book Page 9 Wednesday, August 12, 2015 2:23 PM