Installation Manual

Pre-Installation and Wall-Mounting

2–10 975-0239-01-01 Rev J

This manual is for use by qualified personnel only

2. Lower the Conext XW+ chassis flange onto the mounting plate.

3. Secure the bracket at the top of the Conext XW+ chassis with two #10

self-tapping screws (included).

4. Wall-mount the PDP and any additional Conext XW+ Inverter/Chargers using

the same procedure shown in steps 1-3 (above).

Installation tip The PDP is designed to mount on the right side of the inverter/charger, but it can

be configured to mount on the left side instead. For more information, see the

Conext XW+ Power Distribution Panel Installation Guide.

Installing the Conext XW+ Conduit Box

The Conext XW+ Conduit Box is divided into two parts: the rear panel and the

front panel.

To secure the Conduit Box to the Conext XW+ chassis:

1. Remove both #10 screws from the bottom of the Conext XW+ chassis.

2. Find the keyhole slots located under the top of the rear panel.

3. Align the keyhole slots on the top panel of the Conduit Box with the

corresponding #10 screws on the bottom of the inverter.

4. Secure the Conduit Box to the inverter with the both #10 screws.

Figure 2-8 Conduit Box keyhole alignment

Keyhole slot

XW-NA-Install.book Page 10 Wednesday, August 12, 2015 2:23 PM