Installation Manual

Wiring the Conext XW+ and Conext XW+ PDP
3–4 975-0239-01-01 Rev J
This manual is for use by qualified personnel only
Conext XW+ Power Distribution Panel Internal Faceplate Removal
If you are wiring the Conext XW+ Inverter/Charger to a Conext XW+ Power
Distribution Panel (PDP), you will need to remove the two front faceplates from
the PDP.
For easier access to the faceplates, begin by removing the panel door from its
hinges.
To remove the PDP door:
1. Remove the screw at the top hinge of the PDP door and remove the top
section of the hinge.
2. Using your thumb or forefinger, gently pivot the hinge upward as you remove
the PDP door.
To remove the PDP faceplates:
1. Remove the four screws holding the upper faceplate in place.
2. Remove the four screws holding the lower faceplate in place.
Figure 3-2 Conext XW+ Power Distribution Panel faceplate removal
Internal components hidden for clarity
XW-NA-Install.book Page 4 Wednesday, August 12, 2015 2:23 PM