Installation Manual

Wiring the Conext XW+ Inverter/Charger with a PDP
975-0239-01-01 Rev J 3–11
This manual is for use by qualified personnel only
Installation tip Place the sensor between batteries and place the batteries in an insulated box to
reduce the influence of the ambient temperature outside the battery enclosure.
Making DC Connections
Battery cables
Figure 3-6 Battery Temperature Sensor Installation
OR
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Apply appropriate personal protective equipment (PPE) and follow safe
electrical work practices. See NFPA 70E or CSA Z462.
• This equipment must only be installed and serviced by qualified electrical
personnel.
• Never operate energized with covers removed
• Energized from multiple sources. Before removing covers identify all
sources, de-energize, lock-out, and tag-out and wait 2 minutes for circuits
to discharge
• Always use a properly rated voltage sensing device to confirm all circuits
are de-energized.
Failure to follow these instructions will result in death or serious injury.
XW-NA-Install.book Page 11 Wednesday, August 12, 2015 2:23 PM