Installation Manual

Wiring the Conext XW+ Inverter/Charger with a PDP
975-0239-01-01 Rev J 3–19
This manual is for use by qualified personnel only
To access the AC terminal block, you will need to remove the AC access panel.
For more information, see “Removing the AC Access Panel and PDP Internal
Faceplates” on page 3–2.
The AC terminal block includes three terminals each (L1, L2, and Neutral) for AC
Grid input (AC1), AC Generator input (AC2), and AC Out (AC LOAD)
connections. (see Figure 3-10 on page 3–19.)
The neutral inputs are connected to each other, requiring only one neutral
connection when installed with a Conext XW+ Power Distribution Panel. Without
the PDP, additional neutral connections may be required at the input sources.
Figure 3-10 AC terminal block
AC INAC OUT AC IN
GRID
(AC1)
AC
LOAD
GEN
(AC2)
NL1L2NL1L2NL1 L2
AC INAC OUT AC IN
GRID
(AC1)
AC
LOAD
GEN
(AC2)
NL1L2NL1L2NL1 L2
XW-NA-Install.book Page 19 Wednesday, August 12, 2015 2:23 PM