Installation Manual

Wiring Additional Conext XW+ units with a PDP
975-0239-01-01 Rev J 3–37
This manual is for use by qualified personnel only
Before installing additional Conext XW+ units, disconnect all power from the
system.
Depending on your installation, you may need to perform the following
pre-installation steps:
1. Wall-mount additional Conext XW+ Inverter/Charger(s), as needed. See
“Wall-Mounting the Conext XW+ and PDP” on page 2–9.
2. Install Conext XW+ Conduit Box as needed. See “Installing the Conext XW+
Conduit Box” on page 2–10.
3. Prepare the communications network. See “Communications Network
Preparation” on page 2–12.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Remove watches, rings, or other metal objects.
• This equipment must only be installed and serviced by qualified electrical
personnel.
• Keep sparks and flames away from the batteries.
• Use tools with insulated handles.
• Wear protective glasses, gloves and boots.
• Do not lay tools or other metal parts on top of batteries.
Failure to follow these instructions will result in death or serious injury.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Battery Circuit Breakers must be installed according to the specifications
and requirements defined by Schneider Electric.
• Servicing of batteries must only be performed by qualified personnel
knowledgeable of batteries and the required precautions. Keep
unqualified personnel away from batteries.
• Disconnect the charging source prior to connecting or disconnecting
battery terminals.
Failure to follow these instructions will result in death or serious injury.
XW-NA-Install.book Page 37 Wednesday, August 12, 2015 2:23 PM