Installation Manual

Wiring the Conext XW+ and Conext XW+ PDP
3–44 975-0239-01-01 Rev J
This manual is for use by qualified personnel only
Bypass Interlock Plate Installation
To install the custom designed bypass interlock plate:
1. Replace the upper and lower faceplates on the PDP.
2. Ensure the breakers are in the down position and place the bypass interlock
plate over the breakers, as shown in Figure 3-26, and secure it in place with
the hardware provided.
3. To set it in Normal position, slide the bypass plate to the right, as shown in
Figure 3-26.
Triple Inverter/Charger Installation
This section provides instructions for adding a second and third Conext XW+
Inverter/Charger to your installation. Complete the following installation steps
only after you have already connected the PDP to the first Conext XW+, as shown
in “Wiring the Conext XW+ Inverter/Charger with a PDP” on page 3–7.
Figure 3-26 Installing the custom designed bypass interlock plate
BYPASS POSITION NORMAL POSITION
XW-NA-Install.book Page 44 Wednesday, August 12, 2015 2:23 PM