Installation Manual

Wiring the Conext XW+ and Conext XW+ PDP
3–46 975-0239-01-01 Rev J
This manual is for use by qualified personnel only
4. Connect the positive battery cable to the positive terminal on the second
Conext XW+ (INV2) and the negative battery cable to the negative terminal
on INV2.
5. Connect the positive battery cable for INV3 (included with the Conext XW+
Connection Kit for INV2 INV3 PDP) to the top terminal on the third DC
disconnect/breaker.
6. Connect the negative battery cable for INV3 (included with the Conext XW+
Connection Kit for INV2 INV3 PDP) to the DC Negative Bus.
7. Connect the positive battery cable to the positive terminal on INV3 and the
negative battery cable to the negative terminal on INV3.
Note: Before connecting the DC cables from the PDP to the battery, perform the
procedures in “AC Wiring for a Triple-Inverter System” on page 3–48.
XW-NA-Install.book Page 46 Wednesday, August 12, 2015 2:23 PM