Operation Manual

22
EN
1
A
C
B
2
Shutting off the water and electricity
supplies
Turn off the water tap after every wash cycle to
avoid leaks.
Remove the plug from the socket when cleaning
the machine and when carrying out maintenance
work.
Cleaning the dishwasher
The external surfaces of the machine and the
control panel may be cleaned using a non-
abrasive cloth which has been dampened with
water. Do not use solvents or abrasive
products.
Any marks on the appliance interior may be
removed using a cloth dampened with water
and a little vinegar.
Preventing unpleasant odours
Always keep the door of the appliance ajar in
order to avoid moisture from forming and being
trapped inside the machine.
Clean the seals around the door and detergent
dispensers regularly using a damp sponge.
This will avoid food becoming trapped in the
seals, which is the main cause of the formation
of unpleasant odours.
Cleaning the sprayer arms
Food residue may
become encrusted onto
the sprayer arms and
block the holes used to
spray the water. It is
therefore
recommended that the
arms are checked from
time to time and
cleaned with a small
non-metallic brush.
Cleaning the filters
The filters remove food residue from the water
used in the wash cycle: to obtain the best results
from each wash, they should be cleaned.
Clean the filters regularly.
After cleaning check that the filter assembly has
been replaced correctly.
The dishwasher should not be used without
filters.
1. Remove the filters by pulling the handle
upwards.
2. Clean the filters:
• after every wash
cycle, remove the
largest pieces of
residue from
semicircular plate A
and glass B (these
may be removed by
pulling the handle) by
rinsing them under
running water.
• The entire filter
assembly should be
cleaned thoroughly
once a month: this
includes the
semicircular plate A,
the glass B and the
cylinder C (this may
be removed by turning
it in an anti-clockwise
direction). Use a small
non-metallic brush to clean these parts.
3. Reconstruct the filter assembly and replace it in
the correct position, following movements 1 and 2
as shown in the figure, until it clicks into place.
Leaving the machine unused for
extended periods
Run a wash cycle when the dishwasher is
empty.
Unplug the appliance and disconnect the water
supply.
Leave the door of the appliance ajar.
Care and maintenance
A
B
C
 The dishwasher should not be used without
filters, or when the filter is loose.