Installation Guide

8
Installation (continued)
9
Installing the data cable
□ Install the data cable (1) to the corresponding
push t connection (2) on top of the control
box (O). Ensure that the data cable (1) is fully
inserted and secure it by tightening the nut (3)
by hand in a clockwise direction.
10
Installing the batteries
□ Squeeze the side indicated by the arrows (5) below on the battery pack (P) and then pull down to remove
the cover (1).
1
2
3
O
□ Install four AA batteries (2), make sure the end of "+" on the batteries (2) matches the ends (3) in the
battery pack (P) and the end of "-" on the batteries (2) is matching the ends (4) in the battery pack (P).
□ Reinstall the battery pack cover (1) by pushing up into place.
NOTE: When the sensor ashes 10 times continuously
and slowly, the batteries have lost their charge. Replace
the batteries (2).
P
3
4
P
2
4
P
1
1
1
5
5