Exploded Parts

2272-__ __

Instructions for crystal trimming

STEPS 3 - 5

A or A1

You will need 16 - G11

40 Watts Max

25 Watts recommended

(Supplied - Schonbek #: 30205)

Install bulbs and be sure to test

fixture BEFORE trimming.

THUMB

NUT

POCKET FOR "A" or "A1"

BOTTOM CRYSTAL GRID

#87/323/1SS

DIAGRAM

THUMB NUT

TOP PLATE

1/2"

CABLE

CABLE GLIDER

CABLE GRIPPER

BOTTOM CRYSTAL GRID

#87/322/1SS

4 Install two bottom crystal grids with eight thumb nuts each (already

screwed onto grid) to bottom of the chandelier.

5 Hold chain "A " by the top square crystal. (NOTE: Flat side of large crys-

tals face out and chains are also symmetrical so either end will work!) When

trimming a ST fixture, alternate hanging A & A1 chains. Insert bottom

square crystal into the pocket of bottom crystal grid. Then position the top

connector (between the top two crystals) into the top plate pocket opening

directly above the bottom crystal grid pocket. (Diagram #1) Lower the chain

until the top square stone seats itself into the top plate pocket. When the

chain is installed correctly, it will be held in place by both top and bottom

pockets.