Exploded Parts

ManualsBrandsSchonbek ManualsChandeliersSchonbek Equinoxe 31 Light 30" Wide Crystal Chandelier with Clear Gemcut Crystals

EQUINOXE 2716- __ __

TRIM DIAGRAM

CAUTION... RISK OF ELECTRICAL SHOCK. Make sure the electrical supply to the

chandelier is turned off at the main fuse or circuit breaker before doing any installation. All elec-

trical components must be installed by a licensed electrician in accordance with the National

Electric Code and the appropriate local electrical codes.

HANGING WEIGHT: 50 lbs.

BULBS: 31 - Candle shaped candelabra base B10 bulbs, recommend 25 watts

for best appearance.

60 - Watts Maximum

WARNING: This chandelier meets UL/CSA requirements. Any tampering will void

   UL/CSAcertication.

HIS DESIGN IS THE PROPRIETARY

TRADE DRESS/TRADEMARK OF

SWAROVSKI LIGHTING, LTD.

31 Lights

Diameter: 29-1/2"

Body Length: 23"

IMPORTANT

Please record the following information for future service.

CODE # ________ Four-digit number on outside of carton.

2716-__ __ PAGE 8

(Finish Option)

Summary of content (4 pages)

PAGE 1
EQUINOXE 2716- __ __ TRIM DIAGRAM (Finish Option) T HIS DESIGN IS THE PROPRIETARY TRADE DRESS/TRADEMARK OF SWAROVSKI LIGHTING, LTD. 31 Lights Diameter: 29-1/2" Body Length: 23" CAUTION... RISK OF ELECTRICAL SHOCK. Make sure the electrical supply to the chandelier is turned off at the main fuse or circuit breaker before doing any installation. All electrical components must be installed by a licensed electrician in accordance with the National Electric Code and the appropriate local electrical codes.
PAGE 2
GROUND WIRE WARNING: THIS LUMINAIRE MUST BE MOUNTED OR SUPPORTED INDEPENDENTLY OF AN OUTLET BOX. CEILING LARGE HEX NUTS LOCK NUTS WASHER DIAGRAM 6 RUNNING THREAD DIAGRAM 7 CEILING LOOP CANOPY Installation of Crystals "C" Hold onto small square stone end and turn chain side ways, this will allow connector (connector opening faces to the back) to pass through slot in ring.
PAGE 3
Installation of Grid "30191": Attach (1) Grid DIAGRAM 1 "30191" (with finial attached) with two thumb nuts (already screwed onto grid) to 6 ring. Diagram 1. (See page 5 for location on frame) Grid Ring Installation of Grid "30192": Attach (8) Grids TRIM ID SHEET FOR ORDERING SPARE PARTS. PLEASE SAVE FOR CLEANING FIXTURE! "30192" with two thumb nuts per grid (already screwed onto grid) to 5 ring. Diagram 2.
PAGE 4
RING 1 IMPORTANT: FOLLOW ALL STEPS IN SEQUENCE! 7 TEST POWER TO INSURE PROPER WIRING BEFORE HANGING TRIM ON FIXTURE. MAKE SURE ALL BULBS ARE IN PLACE. 8 Attach (1) Grid "30191" per instructions on page 6, see RING 2 C RING 3 diagram 1 for detailed instructions. Hook Chains "D" into scallopes on ring 5, see diagrams 8 & 9 on page 7 for detailed instructions. NOTE: FLAT SIDE FACES FRONT! 9 Attach (8) Grids "30192" per instructions on page 6, see diagram 2 for detailed instructions.