OWNER’S MANUAL Power Inverter PID-750 Converts DC Battery Power to AC Household Power Includes Battery Cables CAUTION: Read all Safety Rules and Operating Instructions, and follow them with each use of this product. Schumacher Electric Corporation Mount Prospect, IL 60056 U.S.A. Send Warranty Product Repairs to: Customer Service Returns P.O. Box 280, 1025 E.
IMPORTANT SAFETY INSTRUCTIONS Save These Instructions Before using your PID-750, read and understand this Owner’s Manual. • Keep the inverter well ventilated in order to properly disperse heat generated while it is in use. Make sure there are several inches of clearance around the top and sides and do not block the slots of the inverter. • Make sure the inverter is not close to any potential source of flammable fumes, gases or clothing. • Keep the inverter dry.
• Only connect the power inverter to a 12-Volt battery. Make sure the AC plug connection is tight. • Do not modify the AC receptacle in any way. • Use only 45-amp fuses. • This device does not include an internal Ground Fault Circuit Interrupter (GFCI). For GFCI protection, use a Coleman Cable 02822 GFCI outlet.
Make sure the device you are using is compatible with a modified sine wave inverter. operating instructions Connecting to a 12 Volt Battery: The PID-750 battery clamps allow quick hook-up to a 12V battery. Make sure the PID-750 and the device(s) are turned OFF. 1. Unscrew the positive (red) and negative (black) plastic connector knobs from the back of the inverter. 2.
. Turn the device ON. 7. To disconnect the PID-750, reverse the above steps. NOTE: If there is a short circuit or power surge in the device, the alarm will sound. To turn off the alarm, press the button. Cycle inverter power OFF and ON. If problem persists, use a larger inverter or a smaller device. POWER SOURCE Your average automobile or marine battery at full charge will provide an ample power supply to the inverter for approximately 3 hours when the engine is off.
Usage Examples Device Type Estimated Wattage Cell Phones, MP 3 players, Camcorders 10 watts Portable Work Light 25 watts CD/DVD Player 35 watts VCR 40–60 watts Clock Radio 50 watts Laptop 75 watts Stereo System 30–100 watts Game Console (Xbox) 100 watts 12" 3 Speed Fan 230 watts 13" Color TV/VCR Combo 250 watts Blender 300 watts 25" Color TV 300 watts PC & Monitor 400 watts 3/8" Drill 500 watts 6
LED DISPLAY The LED readouts identify the current status of the PID-750. VOLTAGE IN: Voltage of vehicle’s battery or Portable Power jump starter/DC power source. VOLTAGE OUT: Voltage supplied to device through AC receptacle. POWER OUT: Power or wattage supplied to device plugged into the inverter. An audio alarm will sound when the following codes display. To stop the alarm, press the ON/OFF LED Selector button: BaD – Inverter is not functional.
TROUBLESHOOTING PROBLEM: Alarm is On Reason/Solution 1. Display shows SC. Device has a short circuit or demands too much surge power. Cycle inverter power OFF and ON. If problem persists, use a larger inverter or a smaller device. Remove defective device. See warranty and call Customer Service 800-621-5485 (Hours: 7 a.m. – 4:30 p.m. CST). 2. Display shows Lo b. 12 Volt battery too low. Recharge/replace low battery. 3. Display shows Voltage In between 10.5 and 11.0 Volts. 12 Volt battery is low.
5. Display shows HiP. Device demands more than 750 Watts continuous power. Cycle inverter power OFF and ON. If problem persists, use a larger inverter or a smaller device. 6. Display shows HoT. Inverter is too hot. Increase ventilation to inverter. Move inverter to a cooler area. Reduce the power consumption of the device. Inverter will automatically reset after cooling. PROBLEM: Inverter Does Not Turn On Reason/Solution 1. Poor contact at terminals. Unplug and reinsert PID-750. 2. Fuse is blown.
SPECIFICATIONS Maximum Continuous Power.............................. 750 Watts Surge Capacity (Output Wattage)..................... 1500 Watts No Load Current Draw....................................... <.50 Amps Wave Form.......................................... Modified Sine Wave Input Voltage Range.................................... 11 – 15.5V DC Low Battery Alarm................................... 10.7V – 11.3V DC Output Voltage..........................................
Limited Warranty Schumacher Electric Corporation warrants your inverter to be free from defects in material and workmanship, excepting abuse or misuse, for a period of two years from the date of sale to the original user or consumer purchaser. If your inverter malfunctions or fails within the 24-month warranty period because of a defect in material or workmanship, we will repair it without charge or replace it. This warranty is in lieu of all other express warranties.
notes 12
MANUAL DEL DUEÑO Inversor de Potencia PID-750 Convierte Potencia de Batería CC en Potencia Doméstica CA Incluye y Cables de Batería PRECAUCIÓN: Lea todos los Reglamentos de Seguridad e Instrucciones de Operación y sígalos en cada uso de este producto. Schumacher Electric Corporation Mount Prospect, IL 60056 U.S.A. Envíe Productos para Reparación bajo Garantía a: Customer Service Returns P.O. Box 280, 1025 E.
INSTRUCCIONES IMPORTANTES DE SEGURIDAD Guarde Estas Instrucciones Antes de usar su PID-750, lea y entienda este Manual del Dueño. • Mantenga el inversor bien ventilado para dispersar debidamente el calor generado mientras esté en uso. Asegúrese de que haya varias pulgadas de espacio alrededor de la tapa y los lados del inversor. No bloquee las ranuras del inversor. • Asegúrese de que el inversor no esté cerca de ninguna fuente potencial de humos inflamables, gases o ropa. • Mantenga el inversor seco.
• Conéctese el Invertidor de corriente a una batería de 12 Voltios. Asegúrese que la clavija esté bien ajustada. • No modifique el receptáculo CA de ninguna manera. • Use solamente fusible de 45 amperios. • Este dispositivo no incluye Disyuntor de Circuito por Falla a Tierra (GFCI). Para protección GFCI, use un tomacorriente 02822 GFCI de Coleman Cable.
táneo en vataje; sin embargo, hasta los dispositivos con régimen menor que el máximo de 750 vatios pueden exceder la capacidad de aumento del inversor y causar un cierre automático por sobrecarga. Asegúrese de que el dispositivo que se está usando sea compatible con un inversor de onda sinusoidal modificada. INSTRUCCIONES DE OPERACIÓN Para conectar a una batería de 12 voltios: Las pinzas con cables del PID-750 permiten conexión rápida con una batería de 12 voltios.
4. Enchufe el dispositivo en el tomacorriente CA del PID-750. NOTA: Al usar más de un dispositivo, el voltaje combinado total de los dos dispositivos no tiene que sobrepasar los 750 vatios. 5. Para poner el inversor en ON (I) o en OFF (O), Oprima y sostenga el botón por dos segundos. Ponga el inversor en ON. 6. Ponga el dispositivo en ON. 7. Para desconectar el PID-750, invierta los pasos anteriores. NOTA: Si hay cortocircuito o exceso de potencia en el dispositivo, la alarma suena.
Antes de encender el motor, ponga en OFF el dispositivo enchufado en el inversor y el inversor mismo. Para mantener la potencia de la batería, haga que el motor funcione por aproximadamente 10 minutos cada 2 a 3 horas para recargar la batería. Si bien el PID-750 recibe amperaje muy bajo cuando no está en uso, debe quedar desenchufado para evitar desgaste a la batería.
Tipo de Dispositivo Vataje Estimado TV a Colores 25" 300 vatios PC y Pantalla 400 vatios Taladradora 3/8" 500 vatios LECTURAS POR LED Las lecturas por LED identifican el estado actual del PID-750. VOLTAGE IN: El voltaje de la batería del vehículo o del arranque inmediato Portable Power/fuente de potencia CC. VOLTAGE OUT: El voltaje proporcionado al dispositivo mediante el receptáculo CA. POWER OUT: La potencia o vataje proporcionado al dispositivo enchufado en el inversor.
HoT – El inversor está sobrecalentado y automáticamente se apaga por un período de 1-3 minutos para enfriarse. Asegúrese de que el inversor esté bien ventilado. Se reenciende automáticamente después de enfriarse. Lo b – El voltaje de la batería del vehículo es menos de 10.5 voltios. SC – Hay cortocircuito, sobretensión de potencia o sobrecarga en el dispositivo. SOLUCIÓN DE PROBLEMAS PROBLEMA: El Inversor no se Enciende. Causa/Solución 1. La pantalla muestra .
3. La pantalla muestra Voltaje entre 10.5 y 11.0 voltios. La batería de 12 Voltios está baja. Recargue/reemplace la batería baja. El Inversor reenciende automáticamente después de que el voltaje de la batería llegue a 10.5 voltios. 4. La pantalla muestra . El voltaje de 12 voltios está muy alto. Si sucede dentro de un vehículo, repare/reemplace el alternador o el sistema de cargar. Use una batería de 12 voltios de tamaño y régimen apropiados.
PROBLEMA: El Inversor No se Enciende. Causa/Solución 1. Mal contacto en los terminales. Desenchufe y reinserte el Inversor de PID-750. 2. El fusible se quema. Un fusible quemado es normalmente causado por polaridad inversa o cortocircuito dentro del inversor. Para reemplazarlo, póngase en contacto con un écnico de servicio calificado quien hará diagnóstico del inversor y reemplazará el fusible con el reemplazo apropiado. 3. El Inversor puede ser defectuoso.
ESPECIFICACIONES Potencia Continua Máxima.................................750 Vatios Capacidad de Sobretensión (Potencia Pico)....1500 Vatios Requisito de Corriente sin Carga....................... <.50 Amps Forma de Onda...................... Onda Sinusoidal Modificada Rango de Voltaje de Entrada....................... 11 – 15,5V CC Alarma de Batería Baja........................... 10,7V – 11,3V CC Voltaje de Salida....................................... 110V – 125V CA Cierre por Batería Baja..............
Garantía Limitada Schumacher Electric garantiza que su inversor está libre de defectos en materiales o mano de obra, exceptuando el abuso o mal uso, por el período de dos años desde la fecha de venta al usuario original o comprador consumidor. Si su inversor no funciona bien o falla durante el período de la garantía de 24 meses, debido a defecto en materiales o mano de obra, lo repararemos gratis o lo reemplazaremos. La presente garantía reemplaza toda otra garantía expresa.
o la exclusión o limitación de daños incidentales o consecuentes, de modo que las limitaciones o exclusiones anteriores quizás no se apliquen a usted. Esta garantía le concede derechos legales específicos y usted puede también tener otros derechos que varían de estado en estado.
notas 14