Manual

MANUAL SF9003BT

2. SEARCHING AND FINDING

2.1 Automatic satellite search

When the green ON LED lights up, the SAT-Finder HD is ready for

operation and you can align the satellite dish. Be careful not to tilt

the satellite dish too far otherwise you could easily skip the satellite

you are looking for.

In this, the following applies: Pre-adjusting the dish vertically before-

hand will make the subsequent search much easier. Tilt the SAT dish

vertically, depending on your location.

As soon as the SAT-Finder HD has detected the satellite, it is dis-

played with a green LED on the satellite overview and the signal qual-

ity and level are displayed.

QR code online calculator

https://satlex.de/de/azel_calc.html

1. Turn the antenna slowly in the desired direction. As soon as the

antenna detects a satellite, this is indicated by the LEVEL and

QUALITY LEDs.

2. If a satellite has been detected but it is not the one you are looking

for, you now know which orbit position / direction the SAT dish is

pointing to. This makes it possible to search relatively specifical-

ly for the desired satellite. To do this, turn the SAT dish in the

corresponding direction until the SAT-Finder HD switches back to

automatic search mode and thus searches again for the signal of a

satellite.

Repeat this procedure until you have found the desired satellite.