Owner's Manual

1983-88 Ford Thunderbird
1983-88 Mercury Cougar
Radio Removal:
1. Remove two Phillips head sheet metal screws from tray area just forward of radio trim. Remove tray.
2. Remove two Phillips head sheet metal screws from top of radio trim and two Phillips head sheet metal screws from
bottom of radio trim panel.
3. Carefully pull radio trimpanel off.
4. Remove four Phillips head sheet metal screws from radio mounting panel and gently pull radio out of cavity.
5. Disconnect two wiring harnesses at back of radio and disconnect antenna lead. Remove radio.
See Illustration "A"
1984-96 Jeep Cherokee
1985-92 Jeep Comanche
1988-92 Jeep Grand Wagoneer
Radio Removal:
1. Remove two screws from the instrument panel, one from above the cigarette lighter, and one from above the
headlight switch. Unsnap and remove the lower steering column trim piece and remove the trim panel.
2. If equipped with a factory radio, remove the two screws securing the radio brackets to the dashboard.
3. Pull the radio out of the cavity, disconnect
all electrical connections, then remove the
radio.
1986-89 Ford Taurus
Radio Removal:
1. Remove two screws from the bottom of the radio trim panel.
2. Carefully pry on the edges of the trim panel to release the plastic clips and pull the panel away from the dash.
3. Disconnect the power wire for the antenna switch and remove the radio trim panel.
4. Remove four screws from the radio mounting brackets, slide the radio out from the dash, disconnect all electrical, and
remove the radio.
See Illustration "B"
3
USE BRACKETS SHOWN
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
USE BRACKETS
SHOWN
Radio Removal:
1. Remove three screws from the lower edge of the dash trim.
2. Extract three screws from the upper edge of the dash trim.
3. Remove the dash trim.
4. If the vehicle is not equipped with a factory radio, remove two
screws securing the pocket and remove the pocket. If the vehicle
is equipped with a factory radio, remove two screws from the
radio mounting bracket.
5. Pull the radio out of the cavity, disconnect all electrical connections,
then remove the radio.
1984-96 Jeep Wrangler
USE THESE BRACKETS
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.