User manual

IMPORTANT NOTE: If vehicle is equipped with XM tuner box (active or not
active) the BFGMLANXMB harness must be used. The BFGMLANXMB “T”
haness must be installed at the SAT radio Tuner box location.
XM TUNER LOCATIONS: Trucks/SUVs: Behind Glove box, Crossovers:
(Acadia, Traverse, Outlook, Enclave): Left rear side panel, Sedans: Trunk
Tech Tip: Do not mount the BFGMK module near moving or mechanical devices
that may damage the interface. Keep away from any hot surface areas like
heater ducts, direct sun light and metal surface areas that may get hot.
BFGM INTERFACE INSTALLATION
1. Locate XM tuner box in vehicle.
2. Remove harness from the XM tuner.
3. Install BlueFusion “T” harness
into the XM tuner.
4. Plug the 24 pin connector into the
BFGMK BlueFusion interface.
IMPORTANT NOTE: When vehicle is NOT equipped with XM tuner box, the
BFGMHB harness must be used. The BFGMHB “T” harness must be installed
behind the vehicle’s stereo.
TECH TIP: Do not mount the BFGMK module near moving or mechanical de-
vices that may damage the interface. Keep away from any hot surface areas like
heater ducts, direct sun light and metal surface areas that may get hot.
NON-XM INSTALLATION:
1. Remove the factory radio.
2. Remove the 14 and 16 pin
connectors the factory radio.
3. Plug the factory 14 and 16 pin
connectors into (2) BFGMHB
female harnesses.
4. Plug the (2) BFGMHB male
harnesses into the factory radio.
5. Plug the 24 pin connector into the
BFGMK BlueFusion interface.
XM HARNESS
MICROPHONE
24-Pin
3-PIN
XM TUNER
BOX
CAR HARNESS
NON XM HARNESS
MICROPHONE
24-Pin
3-PIN
FACTORY
RADIO
FACTORY HARNESSES
3
VEHICLES WITH SAT TUNER
VEHICLES WITHOUT SAT TUNER