manual

3
REAR
SUPPORT
STRAP
DIN RADIO
5MM SCREWS
CJ1279/CJ1282
MOUNTING PANEL
CJ1279
ISO MOUNTING BRACKETS
CJ1279
TRIM RING
ASSEMBLING THE KIT (Cont'd)
CAUTION:
REAR SUPPORTING
THE RADIO ADDS TO
THE INSTALLATION'S
STRUCTURAL
INTEGRITY.
DIN-ISO MOUNT: (DIN-E Radio with Side Mounting Holes)
1. Snap the DIN iso side mounting brackets to the back of the mounting panel
(1 left and 1 right). Use supplied hardware to bolt them to the back of the
kit panel.
2. Snap the DIN-ISO Trim Ring into the radio opening.
3. Load the Radio from the REAR of the mounting panel
until the nose piece of the radio comes through
the front of the kit.
4. Use the 5MM screws to secure the
radio from the sides.
FACTORY WIRE CODES
For Factory WIring Codes go to: www.scosche-cars.com
Read pages 2-3 for kit assembly.
1995-00 Chrysler Cirrus
1996-00 Chrysler Sebring JX Convertible
1995-00 Dodge Stratus
1996-00 Plymouth Breeze
Radio Removal:
1. Carefully pry out on the radio/heater control trim
bezel, unsnap to remove.
2. Extract two 3/8" bolts holding radio in, unplug and
remove radio.
NOTE: The rear of the aftermarket stereo should
be supported.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
22
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
Read pages 2-3 for kit assembly.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
1993-95 Jeep Grand Cherokee
1992 Jeep Grand Wagoneer
Radio Removal:
1. Extract two screws from above the radio securing the
radio trim bezel.
2. Extract two screws from above the diagnostics display
panel securing the radio trim bezel.
3. Carefully remove the ashtray and extract two screws
located in the ashtray cavity securing the radio trim bezel.
4. Pull the radio trim bezel away from the dash, unplug all
connectors and remove the bezel.
5. Extract two nuts securing the radio to the dash, and pull
the radio from the cavity; unplug all connectors and
remove the radio.
1996-98 Jeep Grand Cherokee
Radio Removal:
1. Extract (5) screws from along top of dash instrument bezel.
2. Carefully pop out wood grain trim panel around a/c heater
control.
3. Carefully pop out wood grain trim panel around headlight
switch.
4. Extract (4) screws from along bottom of dash instrument
bezel, lift up and away to remove.
5. Extract (2) 3/8" hex heard bolts holding radio, unplug
connectors and remove.
Read pages 2-3 for kit assembly.