manual

4
1980-83 Chrysler Cordoba
1980-83 Dodge Mirada
Radio Removal:
1. Remove four screws securing the radio dash
panel: two above the radio and two above
the heater controls.
2. Remove the radio dash panel. Remove two
screws securing the radio to the dash. Pull
the radio out.
3. Disconnect power, antenna, and all speaker
and electrical connections.
1993-97 Chrysler Concorde
1993-97 Dodge Intrepid
1993-97 Eagle Vision
Radio Removal:
1. Pull the radio trim bezel out to release the snap clips,
and remove the bezel.
2. Extract the two bolts securing the radio, pull the
radio from the cavity, unplug all connectors and
remove the radio.
Read pages 2-3 for kit assembly.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
Read pages 2-3 for kit assembly.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
21
Read pages 2-3 for kit assembly.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO RADIO INSTALLATION, SEE PAGE 3.
Radio Removal:
1. Carefully release the spring type fasteners from
the radio/console trim panel - three from along the
top and two from the bottom of the panel.
2. Remove two screws from along the top of the side
console trim pieces, and spread the side piece
out slightly for access to the radio bolt.
3. After spreading the side piece, extract the top
right radio mounting bolt, then remove the bottom
left bolt.
4. Spread the side piece once again to provide
clearance for pulling the radio out of the cavity;
pull the radio out, disconnect the connectors, and
remove the radio.
1989-95 Dodge Spirit
Read pages 2-3 for kit assembly.
1997-01 Jeep Cherokee
Radio Removal:
1. Pop out dash bezel bottom first and remove.
2. Extract (2) screws holding radio, unplug and remove.