Installation manual

IMPORTANT/ PRELIMINARY
ROUTING CABLES AND WIRES
Determine the safest place to run wires through firewall. If it is necessary to drill holes be sure
area is free of any obstructions on either side. Always use a grommet to protect wire.
Be sure to route all wires and cables away from parts that may move or become hot. Excessive
heat will damage the amplifier and wiring. Route power wires away from signal (RCA) cables. If
power wires and signal cables need to intersect cross at a 90% angle. Route RCA cables away
from wires that may carry high current.
-2 -
WARNING: MAKE SURE YOU CHECK TWICE.
DRILLING THROUGH ANY ELECTRICAL
WIRES, FUEL LINES OR ANY OTHER VEHICLE SYSTEMS MAY CAUSE INJURY OR
DEATH.
AMPLIFIER STATUS INDICATOR
LED STATUS INDICATOR
ON
PROT
ON
PROT
POWER: The LED will illuminate in GREEN while amplifier is on.
POWER PROTECT: The LED will illuminate in RED to indicate the Amp is in "Protect Mode",
This may be due to an overload or circuit problem (See page 7-8 for trouble shooting tips).
- 2 -
MONO HIGH POWER CLASS-D AMPLIFIER
ON
PROT
GND
POWER
B
REM
PHASE
HI INPUT
GND
L R
REMOTE
MASTER/SLAVE
SLAVE MASTER
LEVEL
MAX
MIN
BASS
12dB
0dB
LOW PASS
200Hz40Hz0 180
IN
OUT
L
R
L
R
LOW
INPUT
LINE
OUTPUT
SPEAKER