Installation manual

MASTER/SLAVE CONFIGURATION
1000W MONO HIGH POWER CLASS-D AMPLIFIER
ON
PROT
GND
POWER
B
REM
PHASE
HI INPUT
GND
L R
REMOTE
MASTER/SLAVE
SLAVE MASTER
LEVEL
MAX
MIN
BASS
12dB
0dB
LOW PASS
200Hz40Hz0 180
IN
OUT
25A25A25A25A
L
R
L
R
LOW
INPUT
LINE
OUTPUT
SPEAKER
1000W MONO HIGH POWER CLASS-D AMPLIFIER
ON
PROT
GND
POWER
B
REM
PHASE
HI INPUT
GND
L R
REMOTE
MASTER/SLAVE
SLAVE MASTER
LEVEL
MAX
MIN
BASS
12dB
0dB
LOW PASS
200Hz40Hz0 180
IN
OUT
25A25A25A25A
L
R
L
R
LOW
INPUT
LINE
OUTPUT
SPEAKER
SLAVE MASTER
FROM RADIO
SLAVE MASTER
8-AWG JUMPER WIRES
ON THE “-” TERMINALS
TO REMOTE LEVEL CONTROL
If you choose to Slave a second amp, then connect the “Master” audio output on the First amp
to the Slave audio ‘IN” on the Second amplifier. Set the switch on the 2nd Amplifier to the
“Slave” position. Connect the Negative outputs between the amps with NO LESS than 8 AWG
wire. Use the Positive (+) speaker out from the Master to the Positive Subwoofer terminal and
use the Positive (+) Speaker out from the Slave amplifier to the Negative terminal of the SUB.
NOTE: When in Slave mode, all adjustments on Slave amp are by passed.
FOR HIGH LEVEL INPUT
Simply splice the speaker outputs of your radio to the high input harness according to the color code chart
below. For questions or concerns please contact our Tech Support Team at 1-800-6213695 Ex3.
HIGH INPUT HARNESS
GND
L
R
HI INPUT
COLOR CODES
GRAY = Left Positive (+)
BROWN = Left Negative (-)
BLACK = Ground
GREEN = Right Negative (-)
WHITE = Right Positive (+)
IMPORTANT: PLEASE WIRE YOUR STEREO’S SPEAKERS TO
THE HIGH INPUT HARNESS USING THIS COLOR CODE CHART.
- 6 -