Owner's Manual
Table Of Contents
CLIMATE
&
CONVENIENCE
CONTROLS
The Scosche Touch Screen Interface replaces
the
Factory climate, convenience and personalization controls
built into
the
Factory Ford Radio/Dash panel. This solution provides improved ergonomics while adding
touch screen capabilities unique
to
this system. Read the following sections
to
familiarize yourself with the
operating controls and settings.
FIGURE 3
Control
Panel Button
layout
It+
0
[jl
~H---(
6
3
,.....___+-++_
It+
1. Fan speed UP
5.
Defrost
2. Fan speed DOWN 6. Rear Defogger
3. Air conditioning ON/OFF
7.
Circulate
4. Climate power ON/OFF
8.
SET (Settings}
1.
To
increase fan speed, press the fan speed UP button (Fig. 3, #1}. A graphic level indicator
will move
up
on the color TFT screen indicating
the
current fan speed (see page
7,
Fig. 4, #5}.
There are a total
of
6 fan speed increments from
off
to
maximum.
2.
To
decrease fan speed, press the fan speed DOWN button (Fig.
3,
#2}.
A graphic level
- indicator will move down on the color TFT screen indicating the current fan speed (see page
7,
Fig. 4, #5}. NOTE: there will still be a single graphic bar displayed even though fan may be off.
SET
3. Press the Air Conditioning Button (Fig. 3, #3}
to
turn
the
Air Conditioning On
or
Off. A light will
illuminate in
the
button indicating the on/off status
of
the A/C.
4. Press the Power Button (Fig.3, #4}
to
toggle the climate controls On
or
Off.
5. Press the Defrost (Fig. 3, #5}
to
turn Defrost On
or
Off. This configuration helps clear front
windshield
of
fog
or
moisture. Air will be directed
to
the
windshield. A light will illuminate in the
button indicating the
on/off
status
of
the Defrost mode.
NOTE:
For
best
results
clear
the
windows
of
snow
or
ice before
defrost
settings.
DO
NOT
OPERATE VEHICLE UNTIL WINDOWS
ARE
CLEAR!
6. Press the Rear
window
defogger button (Fig. 3, #6}
to
turn the rear
window
defogger on
or
off.
A light will illuminate in
the
button indicating the
on/off
status
of
the Defrost mode. Rear
defogger will also be turned
off
by
turning
the
ignition
to
the OFF position.
7.
Press the recirculation button (Fig. 3,
#7)
to
turn on air recirculation. A light will illuminate in
the button indicating the
on/off
status
of
the Recirc mode. Interior air will
be
re-circulated
inside the vehicle. This
mode
helps
to
quickly cool
the
air inside the vehicle
or
prevent
outside air and odors from entering. Operating recirculation
mode
[while
the
A/C
is off]
increases humidity and may cause
the
windows
to
fog. Recirculation is not available in
the
Defrost
or
Defog modes.
8. Use
the
SET Button (Fig. 3, #8}
to
access touch screen and other vehicle-specific settings.
See "Display Screen Settings"
or
"Initial Setup" sections
for
additional information
5