Owner's Manual

Receiver Wiring Adaptor

120 70-1720

Revision 09/05/13

Individually tape off any unused wires.

White - Left Front Speaker Positive

Violet/Black - Right Rear Speaker Negative

Red - 12 Volts Switched Power

Violet - Right Rear Speaker Positive

Green - Left Rear Speaker Positive

Yellow - 12 Volts Constant Power

Gray - Right Front Speaker Positive

Gray/Black - Right Front Speaker Negative

Green/Black - Left Rear Speaker Negative

White/Black - Left Front Speaker Negative

Black - Chassis Ground (connect to ground wire of new receiver)Blue - Power Antenna

*120701720*

STEP 1 -- MATCH & CONNECT WIRES

Match wires below to the matching function of each wire on your receiver (refer to instructions supplied with receiver). The wire colors of your

new receiver may, or may not, match the wire colors of the adaptor. Match adaptor and receiver wires by function, disregarding color.

Individually tape off any unused wires.

Make final wiring connections following instructions on the next page.

Before starting, compare items on your invoice with items

received. Carefully check through packaging material. If an

item is missing, please call

Crutchfield at 1-888-955-6000.

IMPORTANT

PAGE 1
Receiver Wiring Adaptor 120 70-1720 IMPORTANT Before starting, compare items on your invoice with items received. Carefully check through packaging material. If an item is missing, please call Crutchfield at 1-888-955-6000. Revision 09/05/13 STEP 1 -- MATCH & CONNECT WIRES A. Match wires below to the matching function of each wire on your receiver (refer to instructions supplied with receiver). The wire colors of your new receiver may, or may not, match the wire colors of the adaptor.
PAGE 2
Receiver Wiring Adaptor Connections 120 70-1720 Page 2 STEP 2 -- CONTINUED STEP 2 -- CRIMP CONNECTIONS Tools & Parts Required Wire Stripper/Crimp Tool A. Strip wires back 1/2”. Crimp Caps D. Complete crimp connections for all necessary wires. Generic Illustration E. Be sure to wrap any wires from the Wiring Adaptor that are not necessary (wires with no match from the new receiver) with electrical tape. Receiver Wiring Adaptor Unused Wire (tape over bare wires) STEP 3 -- APPLICATION B.