Owner's Manual

PSM21008
5"
ROUND SIDE VIEW MIRROR
INSTRUCTIONS
STEP
1
Choose a mounting
location
(A).
STEP2
Position
&
mount one
of
the
5"
Side-View Mirrors
to
the appropriate sized clamp
ring
for
the
vehicle
by
clicking *clamp ring* into the base
(B*).
Then use a 3
/1
6"
hex key to fasten
the
screw
&
nut included
with
clamp
(C).
Do
not
fully tighten yet.
STEP3
Use
the
3/16" hex key
to
adjust the mirror's position. Note:
To
adjust the mirror's
horizontal rotation, insert a
1f4"
hex
key
into
hole
on
the
outside
of
the mirror
(D).
Tighten
carefully
once adjustment is
complete.
Note:
Do
not
exceed 415 inch-pounds.
STEP4
Once
positioning is
complete,
tightening
al
3/16"
hex adjustment screws (C).
Continue
until clamp
is
tight
and does
not
move.
Note:
Do
not
exceed 200
inch-pounds.
STEPS
Check mirror position and untighten, adjust
&
re-tighten
if
needed
(D
&
E).
Repeat
for
the other mirror.
STEP6
To
swing mirror out the way
for
safety
or
transport,
loosen
thumb
wheel
under mirror
assembly
enough
to
allow
the
mirror
to
back
ward toward driver. Tighten the
thumb
screw
to
secure the position
(E).
Hand tight
only,
do
not
over tighten.
STEP
7
To
return mirror
to
its
original location, loosen
thumb
wheel
under mirror
assembly
enough
to
allow
the
mirror
to
return
to
the
center
(E).
As you
tighten the
thumb
screw, you will feel 'detent'
that
the
thumb
screw uses
to
secure the position. Hand
tight
only,
do
not
over tighten.
Clamp
Removal:
In-order
to
remove
the tube clamp
from location,
the clamp
must first
be
tightened to
allow
base
removal.
Once
tightened,
loosen
the clamp
and
carefully
squeeze
clamp
to
remove
from the
location.
Note
:
Use
protective
film
to
help
avoid
damage
to the
paint.
*Various
ring
clamp
sizes
available (sold separately
w/
hardware).