Air and Water Cooled Installation and User's Manual

Electrical
The machine is not supplied with a power cord, one
must either be field installed or the machine
hard-wired.
The dataplate on the back of the cabinet details the
power requirements, including voltage, phase,
minimum circuit ampacity and maximum fuse size.
HACR type circuit breakers may be used in place
of fuses. Extension cords are not permitted. Use of
a licensed electrician is recommended.
Electrical connections are made inside the junction
box in the back panel of the ice machine.
1 Remove the junction box cover and route the
power cord through the access hole and
properly attach the power supply wires to the
leads in the junction box.
2 Install a field supplied strain relief per code.
Attach a ground wire to the ground connection
in the junction box.
3 Check voltage when complete.
4 Return the junction box cover to its original
position and secure with the original screws.
Follow all applicable local, state and national
codes.
November 2006
Page 12
C1448, C1848, C2148W
Air and Water Cooled User Manual
Power
Supply
Wires
Ground
Wire
Connection
Install
Strain
Relief