User Manual

WCB6200Q Wireless Network Extender
e Extender is now synced with the gateway/modem’s Wi-Fi settings.
Unplug the Extender and its power cable and continue on to the next
section of this chapter, “Connecting the Extender.”
Connecting the Extender
Now that the Extender is synced with the gateway/modem’s wireless
network, it can be connected to the gateway/modem’s MoCA network
and placed in another area or room of the home/oce. To do this:
1.
Place the Extender in an area where the Wi-Fi signal is weak or
spotty. A coaxial outlet must be available nearby.
2.
Connect the included coaxial cable into the Coax port on the rear
panel of the Extender.
3.
Connect the other end of the coaxial cable into the nearby coaxial
outlet.
4.
Plug the Extender’s power adapter into the Power port of the
Extender, and the other end into an electrical wall outlet.
5.
If applicable, connect an Ethernet cable between one of the Extender’s
LAN ports and the Ethernet port of a non-wireless device (wireless
devices will connect via the wireless network). e conguration
should look similar to the gure, below:
8
Power
Outlet
Power
Adapter
Coaxial
Outlet
Coaxial
Cable
WCB6200Q
Ethernet
Cable
Ethernet Port
of Device
to Connect
to Internet
2-Way
Splitter
Coaxial port
on Device
Coaxial
Cable
Coaxial
Cable
To Coaxial
Outlet
Coaxial
Cable
To Network
Extender
If Coaxial Port is Being Used by Another Device: