User manual

12
English
Control
The iW2 features SRS TruBass® digital sound processing to enhance the audio performance and ensure proper bass response when listening
to your music.
The SRS TruBass function is on by default and can only be turned off or on with the IR remote by pressing the SFX button.
The Front Status LED will flash Green when the SRS TruBass effect is turned OFF or ON via the remote.
SRS TruBass
Firmware update
It may be necessary to update the firmware of your iW2 speaker to ensure the latest compatibility and optimal functionality. The iW2’s
firmware can be updated using a USB Mass Storage device containing a new firmware image downloaded by the user from
www.ihomeaudio.com (register for an iHome account on our website to receive emails about FW updates).
Using a USB Mass Storage device:
1. Download the latest firmware from www.ihomeaudio.com/airplay/support to your computer.
2. Load downloaded firmware to a USB mass storage device.
3. Connect USB device
4. Press & Hold (5 sec).
5. iW2 will scan for firmware file local to the USB device.
If a valid firmware file is found, iW2 firmware will update. If no valid firmware is found, reset the iW2, reload the proper file on USB stick, and
attempt firmware update again.
Note: You will need to reconnect the iW2 speaker to your home network after a firmware update.
During Firmware Update:
When firmware is being updated, all top panel controls icons will light (left to right) indicating progress of the firmware update installation.
All buttons are inactive except for the firmware button. If firmware update is successful, a confirmation (positive) tone will sound.
iW2 Speaker Firmware Updates
The iW2 has an EQ feature that is controlled via the remote that adjusts Bass and Treble.
TREBLE +/- buttons: Adjust treble levels between -5 and +5. Default is 0
BASS +/- buttons: Adjust bass levels between -5 and +5. Default is 0
Note: The Front Status LED will flash Green 3 times when the eq reaches maximum or minimum and then return to last status settings.
RESET button (remote): Resets EQ adjustments to the following state: Bass: 0, Treble: 0.
Note: When Reset button is pressed, Top Panel LEDs will flash 2 times and then return to last status settings.
EQ
100%50%installation = 0%