Installation Guide

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly.
Bulb not included.
1. STEM HUNG INSTALLATION:
A. Choose desired installation height from dimensions
shown in above diagram. Thread fixture wire through
each stem to be used. Please note correct position of
stems from left diagram. Screw all stems together until
secure.
FLUSH MOUNT INSTALLATION:
A. Thread fixture wires through swivel.
B. Screw fixture into swivel.
2. Measure 6" of wire from end of fixture plate and cut
off remaining wire. Split wires and strip off 3/4" of
insulation from each end.
3. Follow enclosed supplement installation instructions
for electrical and fixture installation onto house outlet
box. If you do not have an outlet box at desired
location to attach the fixture than hire a qualified
electrician to create one.
4. Place Shade over threaded socket then spacer tube and
secure with counter ring.
5. Install light bulbs (not included). See label located at
socket area for type and maximum allowed wattage.
Assembly Instructions For
F2248/3
Stems
(4) 12 in. long
(1) 6 in. long
Fixture Plate
(Canopy)
Ball Cap Nut
Swivel
Bulb
(not included)
Spacer Tube
Counter Ring
Socket
Shade
1
2
4
5
3
(E) 10/07
68"
62"
32"
50"
20"
26"
38"
44"
56"
74"