Installation Guide

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulb not
included.
1. Lower the center column and then screw securely into top of
socket assembly while removing any slack in wires in between
parts.
2. Install arms:
A. Install upper section of arms onto top of center column by
fastening with cap nuts (small & smooth).
B. Install lower section of arms onto upper ring by fastening with
cap nuts (larger & knurled).
3. Screw long threaded pipe into coupler located at bottom of
socket assembly. Note correct position of threaded pipe at
illustration.
4. Install stems:
A. Choose desired installation height from dimensions shown in
above diagram. Thread fixture wires through each stems to be
used. Note correct position of stems from left diagram. Screw all
stem together until secure.
B. Pass fixture wires through swivel in canopy and screw top end
of stem assembly into swivel.
5. Follow enclosed supplement installation instructions for electrical
and fixture installation onto house outlet box. If you do not have
an outlet box at desired location to attach the fixture than hire a
qualified electrician to create one.
6. Install light bulbs (not included). See relamping label located near
socket area for type and maximum allowed wattage.
7. A. Insert shade into groove in lower ring.
B. Raise shade until top edge of shade checks inside of upper ring
groove.
C. Lock them into position by carefully raising glass plate and cap,
and then fastening with hex nut. Do not over tighten.
D. Install finial by screwing onto protruding threaded pipe. Do
not over tighten.
Assembly Instructions For
F2343/4
Socket
Assembly
Bulb
(not included)
Upper Ring
Stems
Shade
Canopy
(Fixture Plate)
Cap Nuts
Cap Nut (small)
Cap Nut (large)
(E) 3/08
Swivel
Center Column
Arm
Glass Plate
74-1/4"
62-1/4"
38-1/4"
32-1/4"
26-1/4"
20-1/4"
44-1/4"
68-1/4"
50-1/4"
56-1/4"
Lower Ring
Cap
Hex Nut
Finial
1
4
2B
2A
7
6
3
5