Installation Guide

1A
Install the Fixture
ELECTRICAL BOX
MOUNTING PLATE
MOUNTING PLATE SCREW
CANOPY
THREADED NIPPLE
SCREW COLLAR
COLLAR NUT
LAMP
2
CHAIN
2
If necessary, screw the shorter end of the threaded nipple tightly onto the mounting plate.
Secure the mounting plate to the electrical box with two mounting plate screws.
Screw the shorter end of the long threaded nipple tightly onto the fixture, then place the nipple cover over the long
threaded nipple and secure it by tightening the fixture loop.
Temporarily unscrew and remove the collar nut and screw the screw collar tightly onto the threaded nipple.
Determine the wanted height of the fixture and remove a portion of the chain by opening a link and removing it
from the bottom.
Install the canopy and collar nut onto the chain (in that order), then install the open link onto the fixture loop and
secure it in place by closing the link.
Weave the cord through the chain, screw collar, canopy, threaded nipple, and out of the electrical box. Trim the cord
leaving enough to make electrical connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the electrical box, place the canopy onto the ceiling, and secure it in place by screwing
the collar nut tightly onto the screw collar.
Install the candle tubes by sliding them over the sockets.
Install the shades by properly placing them over the candle tubes and onto the shade bases.
Screw the lamps into the sockets.
1
2
3
4
5
6
7
8
9
10
11
12
LONG THREADED NIPPLE
NIPPLE COVER
3
12
FIXTURE LOOP
Use 120 voltMAX 60 Watt
Candelabra Base Lamp.
SHADE
CANDLE TUBE
SOCKET
2
13
14
3
SHADE BASE
13
14