Installation Guide

Installation Instructions for

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

1.0

990W8518301-8718301-8520701-8720701_-ALB

Outdoor

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing compliant junctionNEC

boxes.

This product is safety listed for wet locations.

Incandescent lamps may be dimmed with a standard incandescent dimmer.

LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer

for additional information.

Alban Outdoor Wall

7400 Linder Ave, Skokie, 160077IL

800.969.3347

www.generationlighting.com

The "Generation Lighting" graphic is a registered trademark of

Generation Lighting. Generation Lighting reserves the right to

change specifications for product improvements without notification.

SAVETHESE INSTRUCTIONS!

8518301, 8718301, 8520701, 8720701

PAGE 1
Installation Instructions for 990W8518301-8718301-8520701-8720701_-ALB Alban Outdoor Wall 8518301, 8718301, 8520701, 8720701 CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Outdoor Use minimum 90°c supply conductors. GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes.
PAGE 2
Install the Fixture 1A 10 GLASS MOUNTING ANCHOR SCREW FIXTURE SCREW FIXTURE BASE MOUNTING PLATE RING 7 9 9 JUNCTION BOX LAMP 6 11 2 3 SOCKET BOTTOM PLATE 8 1 Temporarily install the mounting plate to the junction box and mark the anchor hole locations through the mounting plate holes. Remove the mounting plate. 2 Drill appropriate sized holes at the marked locations and install the anchors. 3 Secure the mounting plate to the junction box. 4 Screw the anchor screws into the anchors.