Installation Guide

2
1A
11
Temporarily install the mounting plate to the junction box and mark the anchor hole locations through the mounting plate
holes. Remove the mounting plate.
Drill appropriate sized holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box.
Screw the anchor screws into the anchors.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
Align the glass to the ring and slide it carefully into the ring allowing it to rest on the bottom plate.
For wet locations, caulk around the base of the fixture with waterproof construction sealant.
1
2
3
4
5
6
7
8
9
10
LAMP
8
MOUNTING
SCREW
9
MOUNTING
PLATE
3
7
6
10
RING
JUNCTION BOX
9
GLASS
FIXTURE BASE
SOCKET
2
8
9
10
11
ANCHOR
FIXTURE
SCREW
BOTTOM PLATE
Install the Fixture