Installation Guide

ManualsBrandsSea Gull Lighting ManualsLightingYorktown 1-Light Black Outdoor Wall Fixture

NOTE: THIS GLASS IS HANDCRAFTED, THE SLIGHT

IMPERFECTIONS IN THE GLASS ADD TO THE

AUTHENTICITY OF THE FIXTURE.

FIGURE 1

INSTALLATION AND SAFETY INSTRUCTIONS

Installation And Safety

Instruction

HC-643

042408

Line art shown may not exactly match the fixture enclosed.

However, the installation instructions do apply to this fixture.

Fill In Item Number On Carton And

File This Sheet For Fixture Reference. ITEM#_________

GLASS (R)

IMPORTANT SAFETY INSTRUCTIONS

*NOT INCLUDED

FIGURE 3

FIXTURES WITH

A ONE PIECE

LAMP / BALLAST

COMBINATION

ONE PIECE

LAMP/

BALLAST

COMBINATION

LAMP (G)

SOCKET (H)

Carefully remove the fixture from the carton and check that all parts

are included, as shown in Figure 1 & 2. Be careful not to misplace

any of the screws or parts which are needed to install this fixture.

STEP 1:

Insert glass (R) into cage (F) (if applicable).

STEP 2:

ASSEMBLY

• Be sure the electricity to the system you are working on is turned

off; either the fuse removed or the circuit breaker set at off.

• Use of other manufacturers components will void warranty, listing

and create a potential safety hazard.

• If you are unclear as to how to proceed, contact a qualified electrician.

• You don’t need special tools to install this fixture.

• Be sure to follow the steps in the order given.

• Under no circumstances should a fixture be hung on house

electrical wires, nor should a swag type fixture be installed on a

ceiling which contains a radiant type heating system.

• Read instructions carefully.

• Proper wiring is essential for the safe operation of this fixture.

• Fixtures with photo-cells should be mounted at least 48" from all

sides to avoid reflection of light back onto Photo-cell, causing the

Photo-cell to malfunction or flicker.

• To reduce the risk of fire, electric shock, or personal injury, mount

to outlet box or supporting system able to support the weight of

the fixture.

•

Save these instructions.

*WIRE CONNECTORS

MOUNTING BAR

OFFSET STRAP (C)

MOUNTING BAR

FLAT STRAP (B)

FIXTURE MOUNTING

SCREWS (I)

*OUTLET BOX

CAP

NUTS (E)

BALL

STUDS (R)

CAGE (F)

FINIAL (Y)

CAUTION:

Fixtures with photo-cells should be mounted at least 48” from

ll sides to avoid reflection of light back onto Photo-cell,

causing the Photo-cell to malfunction or flicker.

Summary of content (2 pages)

PAGE 1
INSTALLATION AND SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS • • • • • • • • • • • Be sure the electricity to the system you are working on is turned off; either the fuse removed or the circuit breaker set at off. Use of other manufacturers components will void warranty, listing and create a potential safety hazard. If you are unclear as to how to proceed, contact a qualified electrician. You don’t need special tools to install this fixture. Be sure to follow the steps in the order given.
PAGE 2
INSTALLATION HC-643 IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX. STEP 1: Hold mounting bar with flat strap (B) behind offset strap (C). Rotate straps so they are at right angles to one another. STEP 2: Insert fixture mounting screws (I) in threaded holes of offset strap (C). Run fixture mounting screws (I) all the way down to the heads.