Installation Guide

Page 1 of 3

INSTALLATION INSTRUCTIONS

SLR SEATS

IMPORTANT: PROPER BACKING MATERIAL AND MOUNTING HARDWARE MUST BE USED TO MOUNT THIS SHOWER SEAT

FOR SAFE USE AND AS REQUIRED BY A.D.A. GUIDELINES.

ADA regulations specify a finished seat height 17” to 19” above the finished floor and 1½” of clearance

between the seat edge and the side wall.

PLEASE READ THESE INSTALLATION INSTRUCTIONS THOROUGHLY PRIOR TO INSTALLING THIS SHOWER SEAT

IMPORTANT: THIS PRODUCT SHOULD ONLY BE INSTALLED BY QUALIFIED AND TRAINED PERSONNEL

FAILURE TO FOLLOW THESE INSTRUCTIONS COULD LEAD TO IMPROPER INSTALLATION OF THE SHOWER

SEAT, STRUCTURAL AND/OR WATER DAMAGE TO THE WALL AND IN-WALL SUPPORT STRUCTURES,

AND/OR SERIOUS BODILY INJURY IN USE. IN ADDITION, ALL WARRANTIES, EXPRESS OR IMPLIED, WILL BE

NULL & VOID DUE TO IMPROPER INSTALLATION OF THIS PRODUCT. THE MANUFACTURER DOES NOT

ASSUME ANY LIABILITY FOR DAMAGE RESULTING FROM SERVICES PERFORMED BY OTHERS, OR FAULTY

INSTALLATION, MISUSE OR MISAPPLICATION OF GOODS.

THIS PRODUCT IS DESIGNED TO MEET OR EXCEED ALL LOAD REQUIREMENTS ESTABLISHED IN THE FEDERAL

SPECIFICATION #WW-P-541/8b AT 250 POUNDS OF FORCE. THE PERFORMANCE OF THIS PRODUCT IS

SIGNIFICANTLY IMPACTED BY THE STRENGTH OF THE WALL TO WHICH IT IS ATTACHED.

TO ASSURE PROPER AND SAFE INSTALLATION, THIS SHOWER SEAT MUST BE INSTALLED INTO A MINIMUM

2” THICK, SOLID WOOD, IN-WALL BACKING MATERIAL. MAKE CERTAIN IN-WALL BACKING COMPLIES WITH

ALL LOCAL BUILDING CODE REQUIREMENTS.

1. Determine desired shower seat location and seat configuration.

TOP VIEW

Determine desired location for the shower seat and

corresponding seat configuration; left or right.

SEAT CONFIGURATION

2. Mounting the seat top to the frame.

Mount the seat top to the frame in the desired configuration.

Using four (4) ¼”-20 x 2” Phillips Flat Head machine screws

and (4) ¼”-20 Nylon Lock Nuts (supplied by manufacturer),

secure the seat top to the frame. Torque screws to 20 ft-lbs.

PAGE 1
INSTALLATION INSTRUCTIONS SLR SEATS IMPORTANT: PROPER BACKING MATERIAL AND MOUNTING HARDWARE MUST BE USED TO MOUNT THIS SHOWER SEAT FOR SAFE USE AND AS REQUIRED BY A.D.A. GUIDELINES. ADA regulations specify a finished seat height 17” to 19” above the finished floor and 1½” of clearance between the seat edge and the side wall.
PAGE 2
INSTALLATION INSTRUCTIONS SLR SEATS 3. Determine seat height from the floor and location relative to the inside back wall. ADA regulations specify a finished seat height 17” to 19” above the finished floor and 1-1/2” clearance between the seat edge and the inside back wall. Check local building codes for additional requirements.
PAGE 3
INSTALLATION INSTRUCTIONS 5. SLR SEATS Determining the Location of the mounting holes for the Sliding Leg Bracket: a. Place the Sliding Leg Bracket around the Leg Support tube and affix the Sliding Leg Bracket against the wall on the established centerline of the seat. Rotate the seat top from down (horizontal) to up (vertical) positions to ensure the Sliding Leg Bracket is positioned properly. Mark the two top holes and the bottom hole in the Sliding Leg Bracket. (See Diagram 5A) b.