Instructions / Assembly

LIFESTYLE & WELLNESS ®
Page 2
of 2
June 2022
INSTALLATION INSTRUCTIONS
Bridgeport Tub Seat
LIFESTYLE & WELLNESS ®
2. Locating and mounting the tub seat in the desired position.
Place the seat in its desired position in the tub
enclosure.
The Positioning Stops will slide along the bottom of the
seat frame to accommodate various tub dimensions.
Position the seat so that the Positioning Stops rest
securely inside the tub dam.
This seat MUST be evenly spaced on the top of the tub
dam and a minimum 2” surface contact MUST be
maintained on both sides of the seat (see diagram
below).
Hand tighten all four (4) Positioning Stops by rotating
each one clock-wise until firmly tightened. Do NOT over-
tighten.
Always ensure each of the four (4) Positioning Stops are
securely tightened and fit snug against the inside of the
tub when this seat is in use.
WARNING:
Serious damage to existing structures and/or physical harm could occur if this product is not used properly.
Do NOT stand on the seat at any time.
To remove this seat, carefully lift it from its
set position on the tub and store in a clean,
dry location for future use.
Once secured to the tub, make certain the seat does not shift from its set position in any direction before use.
THIS COMPLETES THE INSTALLATION OF THE BRIDGEPORT TUB SEAT.