Product manual
Spinpoint M9TU-USB 3.0 Product Manual REV 1.0
12
INSTALLATION
4.4 Cable Connectors
4.4.1 USB Connectivity
The USB interface is connected within a point to point
configuration with the USB host port. There is no master
or slave relationship within the devices. Spinpoint
M9TU-USB 3.0 does not require extra power.
USB3.0 Micro B type applied to Spinpoint M9TU-USB
3.0. Figure 4.3 illustrates USB3.0 Micro B type
connector.
Figure 4-3 USB connector type
Table 4-1 lists the signals connection on the USB interface.
Table 4-1 USB Connector Pin
Definitions
Pin Number Signal Name Description Mating Sequence
1 VBUS Power Second
2 D-
USB 2.0 differential pair
Last
3 D+
4 ID OTG identification
5 GND Ground for power return Second
6 MicB_SSTX-
SuperSpeed transmitter differential pair
Last
7 MicB_SSTX+
8 GND_DRAIN Ground for SuperSpeed signal return Second
9 MicB_SSRX-
SuperSpeed receiver differential pair
Last
10 MicB_SSRX+
Shell Shield Connector metal shell First
4.5 Drive Installation
The Spinpoint M9TU-USB 3.0 hard disk drive can be installed in an USB-compatible system:
• To install the drive with a motherboard that contains USB port, connect the drive to the USB port using a
USB plugs (Micro B type).
• If the drive connects to the USB Hub or Keyboard USB port, make the drive bad detection or bad
operation (because of low bus power).
• If some OS in PC System or Host cannot detection the drive, the system need USB driver installation.