User Manual

Constellation.2 SAS Product Manual, Rev. K 39
6.5.3 Effective altitude (sea level)
a. Operating
–200 to +10,000 feet (–61 to +3,048 meters)
b. Non-operating
–200 to +40,000 feet (–61 to +12,210 meters)
6.5.4 Shock and vibration
Shock and vibration limits specified in this document are measured directly on the drive chassis. If the drive is installed
in an enclosure to which the stated shock and/or vibration criteria is applied, resonances may occur internally to the
enclosure resulting in drive movement in excess of the stated limits. If this situation is apparent, it may be necessary to
modify the enclosure to minimize drive movement.
The limits of shock and vibration defined within this document are specified with the drive mounted by any of the
four methods shown in Figure 8, and in accordance with the restrictions of Section 10.3. Orientation of the side near-
est the LED may be up or down.
6.5.4.1 Shock
a. Operating—normal
The drive, as installed for normal operation, shall operate error free while subjected to intermittent shock not
exceeding 15 Gs at a maximum duration of 11ms (half sinewave). The drive, as installed for normal operation, shall
operate error free while subjected to intermittent shock not exceeding 25 Gs at a maximum duration of 2ms (half
sinewave). Shock may be applied in the X, Y, or Z axis. Shock is not to be repeated more than once every 2 seconds.
b. Operating—abnormal
Equipment, as installed for normal operation, does not incur physical damage while subjected to intermittent
shock not exceeding 40 Gs at a maximum duration of 11ms (half sinewave). Shock occurring at abnormal levels
may promote degraded operational performance during the abnormal shock period. Specified operational perfor
-
mance will continue when normal operating shock levels resume. The drive in abnormal operation may report
recoverable errors to host while subjected to intermittent shock not exceeding 70 Gs for Read / 40 Gs for Write at a
maximum duration of 2ms (half sinewave). Shock may be applied in the X, Y, or Z axis. Shock is not to be repeated
more than once every 2 seconds.
c. Non-operating
The limits of non-operating shock shall apply to all conditions of handling and transportation. This includes both
isolated drives and integrated drives.
The drive subjected to nonrepetitive shock not exceeding 80 Gs at a maximum duration of 11ms (half sinewave)
shall not exhibit device damage or performance degradation. Shock may be applied in the X, Y, or Z axis.
The drive subjected to nonrepetitive shock not exceeding 400 Gs at a maximum duration of 2ms (half sinewave)
does not exhibit device damage or performance degradation. Shock may be applied in the X, Y, or Z axis.
The drive subjected to nonrepetitive shock not exceeding 200 Gs at a maximum duration of 0.5ms (half sinewave)
does not exhibit device damage or performance degradation. Shock may be applied in the X, Y, or Z axis.