Specifications

26
Removing a Celeron

Processor
1. Spread the upright sides if the retention module outwards and lift the CPU upwards
and out of the retention module.
Installing a Celeron

Processor
1. Slide the CPU into the retention module from above such that the edge connector
will slide into the slot1 connector on the motherboard.
2. Push the CPU module down firmly until the notches on the sides of the heat sink clip
into place on the retention module.
3. Change the CPU speed jumpers on the motherboard to match the speed of CPU
you installed. The jumper settings are shown in the previous chapter.
Note: It is possible that your retention module may be different to the one shown,
however the basics of removal and installation will be the same.
Edge connector
CPU
Heat sink
Retention module