Owner`s manual

SECTION 2. PREPARE YOUR MACHINE FOR SEWING
• Wind the Bobbin (Continued)
Draw thread from spool through
bobbin winding tension disc as shown.
J
Pull end of thread through hole in
bobbin as shown.
Place bobbin onto bobbin winding
spindle with end of thread coming
from the top of the bobbin. Push
bobbin winding spindte to the right
until it clicks. Holding onto end of
thread, start machine. When bobbin is
slightly filled, snip off end of thread.
Wind thread until winder stops.
Push bobbin winding spindle to the
left and clip thread. Remove bobbin.
Turn clutch knob away from you
while holding hand wheel for normal
sewing operation.
= Insert the Bobbin into the Bobbin Case
Place bobbin in bobbin case
Pull thread through slot of case
making sure thread feeds clock- as shown.
wise and _s coming from
bobbin as shown.
Pull thread under tension
spring and through the opening
as shown above. Pull 3 to 4
inches of thread from bobbin.
Holding latch open, position
case into shuttle and release
latch.
Case should lock into place
when latch is released.