Owner`s manual

SECT!ON 3. LEARN THE STITCHES

Sew a Button

Sat the Machine

Stitch Stitch selector

Top thread tension Stitch length control

control 't to 4 any number (no?

necessary to adjust)

Zigzag foot

Darnmg plate

!ii';

!!i!

Use the darning plate for button sewin {see p. 18).

1. Set the stitch selector at" €_ "

2. Align the both holes of the button with the slot of the foot and place the left

hole of the button just below the needle point.

3+ Lower the foot and turn the stitch selector to zigzag until the needle point

comes just above the right hole of the button,

4. Sew about five stitches and rinse needle.

5. Set the stitch selector at "' c_ again and sew a few stitches to _ock thread.

To strengthen the shank, cut the

threads leaving a 20 cm (8") tail. Bring

the needle thread down through the

hole in the button and wind it around

the shank.

Draw the thread to the bottom side

and knot.