Owner`s manual

SECTION 5. CARE FOR YOUR MACHINE

= Clean the Shuttle Race

This area must be kept free of dust, lint and occasional tangled thread. Clean the shuttle race area

about every three months.

Center ptn o{

the shutt]e

Lever

case

Shuttte driver

Leve

Shuttle Race L

(Oil here)

Lever

Pointed

Shuttle

Shuttle Race

Cover

To Clean the Shuttle Area:

1, Raise the needle bar to its highest

point and remove the bobbin case.

2. Push shuttle race levers aside. Lift

shuttle race cover and take shuttle out.

3. Clean the shuttle race with a iint

brush.

4. Put a drop of oif on the center pin of

the shuttle and shuttle race. Do not

over-oil.

To Replace Shuttle Assembly:

1, Position shuttle race as illustrated so that shuttle

driver is forming half moon on the left side of the

machme.

2. Ho_d shuttle by center pm and posit=on shuttle so as

to form a half moon on the right side. P6inted hook

will be on the bottom.

3. Place shuttle race cover into place over shuttle

assembly.

4. Snap the levers back into the original position,