Sewing Machine User Manual

Cleaning the Shutlle Race

This area must be kept free of dust, lint and

occasional tangled thread Clean the shuttle race area

about every three months.

o Cleaning the shuttle area

(_ Bobbin case

(_) Levers

Q Shuttle race cover

(_) Shuttle

(_ Shuttle race

(_}') Center pin on the shuttle

Q Shuttle driver

Pointed hook

0 (Oil here)

1- Raise the needle bar to its highest point and remove the

bobbin case (_,

2 Push shuttle race levers (_ aside Lift shuttle race

cover (_Dand take shuttle @ out

3, Clean the shuttle race Owith a lint brush

4, Put a drop of oil on the center pin of the shuttle (_) and

shuttle race 0 Do not over oil

o Replacing shuttle assembly

0 Bobbin case

(_) Levers

(_ Shuttle race cover

0 Shuttle

(_) Shuttle race

(_) Center pin on the shuttle

(Z) Shuttle driver

Pointed hook

@ (Oil here)

1 Position shuttle race (_) as illustrated so that shuttle

driver (Z) is forming half moon on the left side of the

machine

2, Hold shuttle (_ by center pin (_ and position shuttle so as

to form a half moon on the right side The pointed hook(_

will be on the bottom

3 Place shuttle race cover (_) into place over shuttle

assembly

4., Snap the levers (_) back into the original position