Elliptical Trainer User Manual

5. Attach the Seat (3) to the Seat Tube (5) with the two

1/4" x 2" Screws (17). Be sure that the Seat is oriented

as shown.

6. Apply a small amount of grease to the two indicated

shafts of the Pedal Frame (7). Slide a Pedal (12) onto

the right shaft. Make sure that the Pedal is turned so the

plastic tube is facing the Pedal Frame, as shown. Using

the included pedal tool, tap a 1F2"Push Nut (30) onto the

end of the shaft. Be sure that the Push Nut is turned as

shown in the inset drawing.

Attach the other Pedal (12) (not shown) to the left shaft

of the Pedal Frame (7) in the same manner.

Note: Extra 1/2" Push Nuts (30) may have been includ-

ed. Save the Push Nuts and the pedal tool in case

replacement Push Nuts are needed in the future.

7. Before using the CARDIO FORCE, check the Magnet

(18) and the Reed Switch (15), Pivot the Pedal Frame

(7) until the Magnet is aligned with the Reed Switch

(see the inset drawing). Loosen the indicated #8 x 3/4"

Screw (27). Adjust the position of the Reed Switch so

that there is a 1/8" gap between the Magnet and the

Reed Switch. Retighten the Screw.

Make sure that all parts of the CARDIO FORCE are

propedy tightened.

Plastic

Pedal

Tool