Electric Cultivator Operator's Manual

OPERATING INSTRUCTIONS

ADJUSTING THE WHEEL SUPPORT BRACKET

To adjust the wheel support bracket, proceed as follows:

1. Remove cotter pin from the clevis pin and slide pin out of

tailpiece bracket (Fig. 8).

2. Slide the wheel support bracket up or down in the tailpiece,

aligning the holes to the desired height.

3. Place the clevis pin through the hole and secure with a cotter pin.

Fig. 8

WARNING: Avoid accidental starting. Stop motor

and disconnect extension cord prior to adjusting the

wheel support bracket.

USING YOUR CULTIVATOR

1. Move the cultivator to the work area prior to starting the motor.

Transport the cultivator by pushing or pulling it along on its

wheels. Or you may choose to carry the cultivator by its front

handle.

2. Start the cultivator following all steps under STARTING

INSTRUCTIONS on the previous page.

3. With both hands on the upper handle, slowly pivot the cultivator

forward until the tines make contact with the soil.

4. Once the tines are in the ground, cultivate at a moderate pace

until you are familiar with the controls and the handling of the

cultivator.

NOTE: Be aware of the extension cord's location at all times. Never

allow the cultivator's tines to come into contact with the

extension cord while operating.

5. To adjust the cultivating depth, adjust the wheel support

bracket. See Adjusting The Wheel Support Bracket.

NOTE: For cultivation, a two to three inch depth is desirable. When

laying out plant rows, be sure to allow enough width to permit

cultivation between the rows.

WARNING: Never pick up or carry the unit while the

engine is running. Serious personal injury could result

WARNING: Avoid risk of injury. Keep the extension

cord clear of the tilling path at all times. Do not allow

the tines to contact the extension cord