Product Manual

26 •
Measuring procedure The operating concept is based on the typical measuring procedure outlined
below.
• Measure weight and height
• Perform a bioimpedance measurement
• Assign measurements to a seca patient file
• Evaluate measured results
• Save measuring procedure
The order of the tabs on the touchscreen display follows this sequence. It is
possible to operate in a different order.
NOTICE!
Loss of data
If there is no new entry for approx. 5 minutes, the current measure-
ment is discarded. In this case, the complete measuring procedure
will have to be repeated.
► Save or print the measured results immediately after conclusion of
the measuring procedure (see “Closing the measuring procedure”
on page 43).
Automatic standby The device automatically switches to standby if there are no entries on the
device for 5 minutes. This has the following effects:
• measured results and settings which have not been saved are lost.
• the LED of the ON/OFF button is green.
• the touchscreen display goes out.
Switching off the device WARNING!
Electric shock
The device cannot be de-energized by pressing the ON/OFF button.
► Always take out the power supply plug if the device needs to be
de-energized - e. g. for a hygiene treatment.
► Press the ON/OFF button briefly.
The LED of the ON/OFF button is green. The touchscreen display goes
out. The device is on standby.
► Press and hold the ON/OFF button
The LED of the ON/OFF button goes out. The touchscreen display goes
out. The device is switched off.
NOTE:
When switching back on from standby, the device starts immediately
in the
weight/height tab. When the device is switched on having been
switched off, the internal PC boots up again. This takes several sec-
onds.