Product Manual

30 •
Calculating BMI automatically To determine BMI, you have to record the patient's height as well as their
weight.
► After weighing, enter the patient's height.
– Manually (see “Entering height manually” on page 29)
–Via the
seca 360° wireless network (see “Transmitting height via
seca 360° wireless network” on page 29)
The BMI is calculated and displayed automatically.
Switching weighing range
automatically
The scale has 2 weighing ranges. In weighing range 1, there is a low maxi-
mum capacity and the increments of the weight display are more precise. In
weighing range 2, you can use the maximum capacity of the scale.
After the scale is switched on, weighing range 1 is active. If a particular weight
is exceeded, the scale automatically switches to weighing range 2.
To switch back to weighing range 1, proceed as outlined below.
► Completely remove the load from the scale.
Weighing range 1 is active again.
Printing partial results You can print out the measured results so far. Proceed as described in the
section entitled “Printing results report” on page 44.