Product Manual

Configuring the device • 61
English
7. CONFIGURING THE DEVICE
7.1 Adapting default module selection for bioimpedance analysis
The default module selection determines which evaluation modules are
considered during a bioimpedance analysis.
The device is factory set, so that when the
bia tab is activated, the Default
module selection
dialog window appears and all evaluation modules are acti-
vated. This way, the module selection can be verified before each measure-
ment and, if necessary, adapted to suit the individual measurement.
The device can be configured in such a way that the
Default module selection
dialog window does not appear if the bia tab is activated. You can also create
an in-house default module selection.
Showing/hiding default module
selection
In order to determine whether or not the Default module selection dialog
window is displayed before each bioimpedance analysis, proceed as outlined
below.
1. Press the
switch menu button.
The secondary menu is displayed.
2. Press the
settings button.
The
User menu appears.
The current setting is displayed (button appears gray = pressed).
3. Press the desired setting.
–
No: default module selection is active. It is displayed before every
bioimpedance analysis and can be adapted to suit the measure-
ment in question.
– Yes: default module selection is active but is not displayed before
the bioimpedance analysis. Adaptations to the default module se-
lection are possible only in the
settings menu.
4. Press the apply button.
The module selection is saved and available from the next bioimpedance
analysis.