Manual

… the display E and XX.XX appear?

– Switch off the scale with the Start key and start the scale again. The scale will then

work normally again.

If this is not the case, disconnect the power supply by briefly removing the batteries or

unplugging the mains supply from the scale. If this measure is equally unsuccessful,

inform the Service department.

8. Servicing/recalibration

Have the scale recalibrated by authorised persons in accordance with national legal re-

quirements. The year of initial calibration can be found behind the CE symbol on the rating

plate above the number of the appointed office, 0109 (Hessen Weights & Measures Of-

fice). Recalibration is essential if one or more security marks are damaged.

We recommend having your scale serviced by your local service agent before having it

recalibrated. seca Customer Service will be pleased to give you further assistance.

Changing the batteries

When or bAtt appear in the display, you should change the batteries. You need

6 type AA 1.5 V batteries.

– Carefully turn over the scale so that the

base of the scale is accessible.

– Push the battery compartment closure

towards “Battery” and open the cover.

– Take out the holder and batteries.

– Remove the used batteries and insert

new batteries in the holder.

Check that the polarity is correct.

– Place the holder and batteries in the

battery compartment.

– Close the cover.

– Then turn the scale back up the right

way.