User's Manual

Second Wind Air Purifier lamps are designed to be on all the time. After approximately 9000-11000 hours of

operation the lamps intensity will decrease. Installation of a replacement lamps is best handled by a HVAC

Contractor.

Both lamps must be replaced at the same time for the MODEL 1000KCS.

1 Turn unit off and make sure the power is off

to the unit.

Wait for lamp to cool.

2 Remove screws from around the unit, do not

remove the screws from the hinge. (Fig.13)

3 Drop unit down, it will remain attached to the

duct via the hinge. (Fig.14)

4 Carefully remove lamp from brass lamp hold-

ers. (Fig.15)

5 Remove lamp connector from end of lamp.

(Fig.16 & Fig.17)

6 Install new lamp into socket and snap into

brass holders.

7 Return unit to upright position against duct

and re-attach with screws.

8 Power unit up and turn on.

NOTE

UV Lamps contain mercury like other

fluorescent lamps and must be disposed of

properly. Do not throw old lamps in the

trash. Contact your local waste collection

agency for proper disposal procedures.

If the lamps are dirty or have fingerprints

on them, use alcohol to remove. The

1000kcs purifier has 2– different lamps.

1. 1-split lamp part # 1068

2. 1– straight lamp part # 1068A