Instructions / Assembly

8
Quick Start
NOTE: All sensors included with your kit have already been paired/synced to the alarm host and ready to go.
Make sure you remove any plastic wraps from the batteries provided before inserting them. After powering up
the host and all wireless sensors, please test all the senors first to ensure they operate well before mounting your
sensors. Please refer to each sensors syncing procedure if it does not show up on the Smartphone app.
ALARM HOST (SM-025H)
Insert the female end of the AC adapter into the DC IN port located at the bottom of the host and connect the other
end into a wall outlet. Then connect one end of the Ethernet cable into the Ethernet port (also located at the bottom
of the alarm host) and the other end into your wireless router. Make sure you use the cable management grooves
to help keep the cables organized.
NOTE: The Ethernet cable is only required for setup and can be removed once you connect the host to your Wi-Fi
network.
DOOR/WINDOW SENSOR (SM-002M)
Using a small flat head screw driver, gently pry open the back cover from the larger of the two pieces and Insert
the AA battery provided (Make sure the + and – polarities are correct). Once the battery is inserted re-attach the
back cover and test the sensor by separating the small magnetic piece from the flat side of the larger piece. You
should get a flashing red light every time the two pieces are separated. Keep in mind the gap between the two
pieces must be within ¼ of an inch for it to work properly.
INSIDE VIEW OF SENSOR
BOTTOM VIEW OF HOST
STEP 1 HARDWARE SETUP